What's in the box
Two clips, two inserts, two bolts and two nuts. Insert screws are sold separately.
12x Insert
22x Clip
32x Bolt
42x Nut
Screw the insert to your accessory
Use two countersunk screws per insert, sized for what you're mounting (not included).
12x screws
2Insert
3Accessory
Fit the clip over the tube
Each clip is made to fit your tube size. Shown here on 1¼" square tube.
Add the bolt and nut
Slide the bolt through both arms and thread the nut on the other side.
Tighten with a flat-head screwdriver
Tightening pulls the arms together and clamps the clip to the tube.
1Screwdriver
2Arms pull together
Drop the insert into the slot
The slot opens one way only, so the insert seats on the clip's floor.
Mount the top clip upside down
Its slot now opens downward.
1Slot opens down
2Top clip
Push the accessory up into the top clip
The top insert slides up into the slot.
1Push up
2Insert enters slot
Slide the bottom clip up under the lower insert
The lower insert drops into its slot. Then tighten both bolts.
1Slide up
2Tighten both bolts
Locked in place
A clip above and a clip below keep it from sliding out.